二次退火温度对无取向硅钢组织和磁性能的影响

doi:10.13251/j.issn.0254-6051.2021.03.013

金属热处理 ›› 2021, Vol. 46 ›› Issue (3): 67-70.DOI: 10.13251/j.issn.0254-6051.2021.03.013

二次退火温度对无取向硅钢组织和磁性能的影响

陆佳栋, 吴圣杰, 岳重祥, 李化龙

江苏省沙钢钢铁研究院, 江苏张家港 215625

收稿日期:2020-09-03 出版日期:2021-03-25 发布日期:2021-05-08
通讯作者: 吴圣杰,硕士,工程师,E-mail:shengjiewu@126.com
作者简介:陆佳栋(1995—),男,工程师,主要研究方向为无取向硅钢产品开发,E-mail:13861866056@163.com。

Effect of secondary annealing temperature on microstructure and magnetic properties of non-oriented silicon steel

Lu Jiadong, Wu Shengjie, Yue Chongxiang, Li Hualong

Institute of Research of Iron and Steel,Shasteel, Zhangjiagang Jiangsu 215625, China

Received:2020-09-03 Online:2021-03-25 Published:2021-05-08

摘要/Abstract

摘要： 对1.2%Si无取向硅钢进行不同温度的二次退火试验,研究了不同二次退火温度对无取向硅钢组织和磁性能的影响。结果表明:二次退火能显著增大铁素体晶粒尺寸,降低无取向硅钢铁损;在780~820 ℃下进行二次退火,铁损降幅最大,达到1.0 W/kg,无取向硅钢的磁性能达到最佳水平,此时平均晶粒尺寸为83~114 μm。通过扫描电镜对不同温度二次退火后的试样进行析出物统计,发现试样中的析出物主要为MnS-Cu_xS,当二次退火温度为780~820 ℃时,0.1~0.2 μm的细小MnS-Cu_xS析出物比例最低。

关键词: 无取向硅钢, 二次退火, 磁性能, 析出物

Abstract: Secondary annealing experiment of 1.2% Si non-oriented silicon steel at different temperatures were carried out, and the effect of secondary annealing temperature on the microstructure and magnetic properties of the steel was investigated. The results show that the grain size of ferrite is increased and the core loss is reduced after secondary annealing processes. The core loss of experimental steel is reduced significantly in the annealing temperature range of 780-820 ℃. In this temperature range, the magnetic properties of non-oriented silicon steel is the best, the core loss reduction is 1.0 W/kg, and the average grain size is 83-114 μm. Besides, the precipitates of the experimental steels were investigated by means of SEM. The results show that the main precipitate in the experimental steel is MnS-Cu_xS. The amount of fine MnS-Cu_xS precipitate with the size of 0.1-0.2 μm is the lowest in the annealing temperature range of 780-820 ℃.

Key words: non-oriented silicon steel, secondary annealing, magnetic properties, precipitate

中图分类号:

TG156.23

陆佳栋, 吴圣杰, 岳重祥, 李化龙. 二次退火温度对无取向硅钢组织和磁性能的影响[J]. 金属热处理, 2021, 46(3): 67-70.

Lu Jiadong, Wu Shengjie, Yue Chongxiang, Li Hualong. Effect of secondary annealing temperature on microstructure and magnetic properties of non-oriented silicon steel[J]. Heat Treatment of Metals, 2021, 46(3): 67-70.

参考文献

[1] 何忠治,赵宇,罗海文.电工钢[M].北京:冶金工业出版社,2012.
[2] Xia Z S,Kang Y L,Wang Q L.Developments in the production of grain-oriented electrical steel[J].Journal of Magnetism and Magnetic Materials,2008,320(23):3229-3233.
[3] 曹树卫,申勇,孙江美.浅析电工钢的生产现状及技术发展[J].轧钢,2008(5):35-38.
Cao Shuwei,Shen Yong,Sun Jiangmei.Brief discussion about production situation and technical development of electrotechnical steel[J].Steel Rolling,2008(5):35-38.
[4] Wan Y,Chen W Q,Wu S J.Effect of lanthanum content on microstructure and magnetic properties of non-oriented electrical steels[J].Journal of Rare Earths,2013,31(7):727-733.
[5] Yousuke K,Hisashi M,Hiroyasu F,et al.Importance of punching and workability in non-oriented electrical steel sheets[J].Journal of Magnetism and Magnetic Materials,2008,320(20):2474-2480.
[6] Park J T,Szpunar J A.Effect of initial grain size on texture evolution and magnetic properties in non-oriented electrical steels[J].Journal of Magnetism and Magnetic Materials,2009,321(13):1928-1932.
[7] 刘杰,王全礼,罗文彬,等.临界变形对半工艺冷轧无取向电工钢组织性能的影响[J].金属热处理,2009,34(1):50-54.
Liu Jie,Wang Quanli,Luo Wenbin,et al.Effects of critical deformation on microstructure and properties of semi-processed cold non-oriented electrical steel sheet[J].Heat Treatment of Metals,2009,34(1):50-54.
[8] Campos M F D,Sablik M J,Landgraf F J G,et al.Effect of rolling on the residual stresses and magnetic properties of a 0.5% Si electrical steel[J].Journal of Magnetism and Magnetic Materials,2008,320(14):377-380.
[9] 欧昊,张祥林.基于残余应力与磁畴观察的2%Si无取向硅钢冲裁冲片的最佳退火温度[J].材料热处理学报,2019,40(9):95-99.
Ou Hao,Zhang Xianglin.Optimum annealing temperature of 2%Si non-oriented silicon steel based on residual stress test and magnetic domain observation[J].Transactions of Materials and Heat Treatment,2019,40(9):95-99.
[10] Cao H,Hao L,Yi J,et al.The of punching process on residual stress and magnetic domain structure of non-oriented silicon steel[J].Journal of Magnetism and Magnetic Materials,2016,406:42-47.
[11] 张文康,毛卫民,白志浩.退火温度对冷轧无取向硅钢组织结构和磁性能的影响[J].特殊钢,2006,27(1):15-17.
Zhang Wenkang,Mao Weimin,Bai Zhihao,Influence of annealing temperature on structure texture and magnetic properties of cold rolled non-oriented silicon steel[J].Special Steel,2006,27(1):15-17.
[12] Lu Y L,Zu G Q,Luo L,et al.Investigation of microstructure and properties of strip-cast 4.5wt% Si non-oriented electrical steel by different rolling processes[J].Journal of Magnetism and Magnetic Materials,2019,497:165975.
[13] Jenkins K,Lindenmo M.Precipitates in electrical steels[J].Journal of Magnetism and Magnetic Materials,2008,320(20):2423-2429.
[14] 吕学均,张峰,王波,等.夹杂物对无取向硅钢磁性能的影响[J].特殊钢,2012,33(4):22-25.
Lü Xuejun,Zhang Feng,Wang Bo,et al.Effects of inclusions on magnetic properties of non-oriented silicon steel[J].Special Steel,2008,320(20):2423-2429.
[15] 缪乐德,张毅,张峰,等.不同牌号无取向硅钢夹杂物定性定量分析[J].冶金分析,2012,32(10):7-15.
Miao Lede,Zhang Yi,Zhang Feng,et al.Qualitative and quantitative analysis of inclusions in non-oriented silica steel with different trademark[J].Metallurgical Analysis,2012,32(10):7-15.
[16] Liu Y,Zhang X,Wang P,et al.Investigation on inclusions in non-oriented silicon steels[J].Metallurgical and Materials Transactions,2020,51(1):22-26.

二次退火温度对无取向硅钢组织和磁性能的影响

Effect of secondary annealing temperature on microstructure and magnetic properties of non-oriented silicon steel

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价

[1]	章建军, 庄晓伟, 汤晓峰. 提高低碳钢磁性能的球化退火工艺试验[J]. 金属热处理, 2022, 47(4): 182-184.
[2]	范合合, 金自力, 任慧平, 游兴华. 高Nb-Ti新能源汽车用无取向硅钢热轧过程的再结晶行为[J]. 金属热处理, 2022, 47(1): 88-93.
[3]	罗建东, 杨颖仪, 林育周. 离子扩渗工艺对316L不锈钢表层组织及磁性能的影响[J]. 金属热处理, 2021, 46(7): 207-211.
[4]	麻衡, 霍孝新, 吴红艳, 高秀华, 杜林秀. Q550D钒氮钢特厚板组织性能与表面质量[J]. 金属热处理, 2021, 46(4): 65-69.
[5]	石晓霞, 任慧平, 李晓, 王超, 宫鑫. 26CrMoVNbRE钢高效热处理调质工艺边界探索[J]. 金属热处理, 2021, 46(3): 39-45.
[6]	宋苏, 陈文智, 张广强, 刘洋, 郑伟, 张迁, 周少雄. 高饱和磁感Fe₈₂Si_3.8B_13.9C_0.3非晶铁芯的退火及浸漆工艺[J]. 金属热处理, 2021, 46(2): 61-65.
[7]	马圆圆, 包汉生, 龚志华, 赵吉庆, 杨钢. 热处理对0Cr13钢力学性能和磁性能的影响[J]. 金属热处理, 2021, 46(12): 87-93.
[8]	张超汉, 陶平均, 朱坤森, 黄文豪, 杨元政. Ni合金化对Finemet合金热稳定性及软磁性能的影响[J]. 金属热处理, 2021, 46(12): 119-123.
[9]	刘岩, 张城兴, 李双喜. 工业纯铁的氮碳钛离子共渗工艺[J]. 金属热处理, 2021, 46(12): 252-255.
[10]	沈智, 晏建武, 金康, 周英丽, 殷剑. 制备工艺对超磁致伸缩Fe-Ga合金薄膜表面形貌的影响[J]. 金属热处理, 2021, 46(11): 236-240.
[11]	王志磊, 车尚峰, 侯迪文, 方烽, 张元祥, 王洋, 张晓明. 薄带连铸3.4%Si无取向硅钢的组织、织构演变及性能[J]. 金属热处理, 2021, 46(10): 18-25.
[12]	刘阳, 金自力, 任慧平, 汲霖. 加热温度对高Nb-Ti新能源汽车用无取向硅钢第二相固溶行为的影响[J]. 金属热处理, 2021, 46(10): 34-38.
[13]	刘天成, 潘贇, 李广敏, 敫立国, 崔克胜. FeCoNiSiB非晶合金感生各向异性对磁性能的影响[J]. 金属热处理, 2021, 46(10): 53-57.
[14]	宋苏, 陈文智, 张广强, 郑伟, 张迁, 邢彦兴, 周少雄. 新型Fe_80.5Si_7.2B_12.3非晶合金带材的退火工艺与磁性能[J]. 金属热处理, 2021, 46(1): 104-108.
[15]	王科强, 刘仁东, 郭金宇, 付薇, 黄秋菊, 孙荣生. 汽车用800 MPa级冷轧低合金高强钢的研制[J]. 金属热处理, 2021, 46(1): 120-124.