均匀化处理对Mg-9.8Gd-3.5Y-2Zn-0.5Zr合金微观组织的影响

doi:10.13251/j.issn.0254-6051.2022.10.001

摘要/Abstract

摘要： 采用DSC、SEM、EDS、OM等检测方法研究了Mg-9.8Gd-3.5Y-2Zn-0.5Zr合金铸锭在505~535 ℃均匀化处理0~84 h后的组织演变规律。结果表明,铸态组织呈枝晶状,第二相含量为19.86%,晶间第二相主要由白色点状共晶相和块状LPSO相组成,晶内第二相为少量针状LPSO相、花瓣状Zr团簇相和方形富稀土相。均匀化处理后的LPSO相形貌为晶间块状和晶内片层状两种。晶内片层状LPSO相的含量受均匀化温度和均匀化时间的影响。在505~525 ℃下,晶内片层状LPSO相随均匀化温度的升高,生长速度加快,数量增多。在相同均匀化温度下延长保温时间,晶内片层状LPSO相沿晶界向基体内部析出,贯穿晶粒后开始粗化。535 ℃下晶间块状LPSO相转变为W相,晶内片层状LPSO相溶解进入基体。晶间LPSO相对晶界迁移起钉扎作用,在505~525 ℃均匀化,随着保温时间的延长,晶粒长大幅度并不明显。在535 ℃均匀化,晶间LPSO相大量溶解,晶粒开始急剧长大。

关键词: Mg-9.8Gd-3.5Y-2Zn-0.5Zr镁合金, 均匀化处理, LPSO相, 微观组织

Abstract: Microstructure evolution of Mg-9.8Gd-3.5Y-2Zn-0.5Zr alloy ingot after homogenization treatment at 505-535 ℃ for 0-84 h was studied by means of DSC, SEM, EDS and OM. The results show that the as-cast microstructure is dendrite, and the content of the second phase is 19.86%. The intergranular second phase mainly consists of white spot-like eutectic phase and massive LPSO phase, and the intragranular second phase consists of a small amount of needle-like LPSO phase, petal-like Zr cluster phase and square rare-earth rich phase. The morphology of LPSO phase after homogenization treatment is intergranular block and intragranular lamellar. The content of intragranular lamellar LPSO phase is affected by homogenization temperature and time. At 505-525 ℃, the growth rate of intragranular lamellar LPSO phase increases with the increase of homogenization temperature. The intragranular lamellar LPSO phase precipitates along the grain boundary into the matrix with the extension of holding time at the same temperature and begins to coarse after penetrating the grain. At 535 ℃, the intergranular massive LPSO phase transforms into W phase, and the intragranular lamellar LPSO phase dissolves into matrix. The intergranular LPSO phase plays a role of pinning relative to grain boundary migration. Homogenized at 505-525 ℃, with the extension of holding time, grain growth is not obvious. Homogenized at 535 ℃, the intergranular LPSO phase dissolved in large quantities and the grains begin to grow rapidly.

Key words: Mg-9.8Gd-3.5Y-2Zn-0.5Zr magnesium alloy, homogenization treatment, LPSO phase, microstructure

中图分类号:

TG146.22

黄元春, 王舟, 马尚坤. 均匀化处理对Mg-9.8Gd-3.5Y-2Zn-0.5Zr合金微观组织的影响[J]. 金属热处理, 2022, 47(10): 1-9.

Huang Yuanchun, Wang Zhou, Ma Shangkun. Effect of homogenization treatment on microstructure of Mg-9.8Gd-3.5Y-2Zn-0.5Zr alloy[J]. Heat Treatment of Metals, 2022, 47(10): 1-9.

参考文献

[1]刘运腾, 林涛, 周吉学, 等. 低挤压比条件下挤压工艺对AZ31B镁合金组织和力学性能的影响[J]. 热加工工艺, 2017, 46(5): 52-55, 59.
Liu Yunteng, Lin Tao, Zhou Jixue, et al. Effect of extrusion process on microstructure and mechanical properties of AZ31B magnesium alloy at low extrusion ratio[J]. Hot Working Technology, 2017, 46(5): 52-55, 59.
[2]韩二锋, 高洁, 黄瑞. 固溶时效对Mg-Gd-Y合金显微组织和力学性能的影响[J]. 金属热处理, 2017, 42(5): 78-83.
Han Erfeng, Gao Jie, Huang Rui. Effects of solid solution and aging process on microstructure and mechanical properties of Mg-Gd-Y alloy[J]. Heat Treatment of Metals, 2017, 42(5): 78-83.
[3]Zhou X, Liu C, Gao Y, et al. Microstructure and mechanical properties of extruded Mg-Gd-Y-Zn-Zr alloys filled with intragranular LPSO phases[J]. Materials Characterization, 2017, 135: 76-83.
[4]杜玥. Mg-13Gd-3.5Y-2Zn-0.5Zr合金往复镦——挤变形组织演变研究[D]. 太原: 中北大学. 2018.
Du Yue. Microstructure evolution of Mg-13Gd-3.5Y-2Zn-0.5Zr alloy fabricated by repetitive upsetting and extrusion[D]. Taiyuan: North University of China, 2018.
[5]邵兴洲. Mg-Gd-Y系镁合金组织性能研究[D]. 重庆: 重庆大学, 2012.
Shao Xingzhou. Study on organization and mechanism of Mg-Gd-Y alloy[D]. Chongqing: Chongqing University, 2012.
[6]徐超. 高强Mg-Gd-Y-Zn-Zr合金的轧制变形及时效强化行为[D]. 哈尔滨: 哈尔滨工业大学, 2012.
Xu Chao. Rolling deformation and aging strengthening behavior of High strength Mg-Gd-Y-Zn-Zr alloy[D]. Harbin: Harbin Institute of Technology, 2012.
[7]Matsuda M, Ii S, Kawamura Y. Variation of long-period stacking order structures in rapidly solidified Mg97Zn1Y2 alloy[J]. Materials Science and Engineering A, 2005, 393(1): 269-274.
[8]Chen T, Chen Z, Shao J, et al. Evolution of LPSO phases in a Mg-Zn-Y-Gd-Zr alloy during semi-continuous casting, homogenization and hot extrusion[J]. Materials and Design, 2018, 152: 1-9.
[9]Kim J K, Ko W S, Sandlöbes S, et al. The role of metastable LPSO building block clusters in phase transformations of an Mg-Y-Zn alloy[J]. Acta Materialia, 2016, 112: 171-183.
[10]鲁礼菊, 许诗源, 刘木君. 冷却方式对均匀化态Mg-6Gd-3Y-1Zn-0.5Zr镁合金显微组织及腐蚀性能影响研究[J]. 兵器材料科学与工程, 2017, 40(2): 13-16.
Lu Liju, Xu Shiyuan, Liu Mujun. Influence of cooling methods on microstructure and corrosion property of Mg-6Gd-3Y-1Zn-0.5Zr magnesium alloy[J]. Ordnance Material Science and Engineering, 2017, 40(2): 13-16.
[11]庞铮. 稀土镁合金中LPSO相演化规律及其对再结晶的影响研究[D]. 北京: 北京有色金属研究总院, 2021.
Pang Zheng. Study on the evolution regulations of LPSO phase and its effect on recrystallization in rare earth magnesium alloys[D]. Beijing: General Research Institute for Nonferrous Metals, 2021.
[12]Wu Y J, Zeng X Q, Lin D L, et al. The microstructure evolution with lamellar 14H-type LPSO structure in an Mg_96.5Gd_2.5Zn₁ alloy during solid solution heat treatment at 773 K[J]. Journal of Alloys and Compounds, 2008, 477(1): 193-197.
[13]鲁若鹏. Mg-Zn-Y合金中LPSO相的调控及其对阻尼和力学性能的影响机制研究[D]. 重庆: 重庆大学, 2015.
Lu Ruopeng. Microstructure evolution of LPSO phase and the corresponding damping capacities and mechanical properties in Mg-Zn-Y alloys[D]. Chongqing: Chongqing University, 2015.
[14]潘吉鹏. 铸造GW83K镁合金疲劳应变局域化与裂纹萌生行为研究[D]. 上海: 上海交通大学, 2019.
Pan Jipeng. Study on the fatigue strain localization and crack initiation behaviors of cast GW83K magnesium alloys[D]. Shanghai: Shanghai Jiao Tong University, 2019.
[15]Qian M, StJohn D H, Frost M T. Characteristic zirconium-rich coring structures in Mg-Zr alloys[J]. Scripta Materialia, 2002, 46(9): 649-654.
[16]黄太红, 宋鹏, 周会会, 等. 固溶温度对Mg-10Gd-3Y-1.2Zn-0.5Zr合金的组织演变规律和时效硬化行为的影响[J]. 稀有金属材料与工程, 2016, 45(2): 431-435.
Huang Taihong, Song Peng, Zhou Huihui, et al. Effects of solution temperature on microstructure evolution and aging hardness of Mg-10Gd-3Y-1.2Zn-0.5Zr alloy[J]. Rare Metal Materials and Engineering, 2016, 45(2): 431-435.
[17]Liu Huan, Bai Jing, Yan Kai, et al. Comparative studies on evolution behaviors of 14H LPSO precipitates in as-cast and as-extruded Mg-Y-Zn alloys during annealing at 773 K[J]. Materials and Design, 2016, 93: 9-18.
[18]Zhou Xiaojie, Liu Chuming, Gao Yonghao, et al. Evolution of LPSO phases and their effect on dynamic recrystallization in a Mg-Gd-Y-Zn-Zr alloy[J]. Metallurgical and Materials Transactions, 2017, 48(6): 3060-3072.
[19]闫钊鸣, 张治民, 杜玥, 等. 均匀化处理对Mg-13Gd-3.5Y-2Zn-0.5Zr镁合金组织和力学性能的影响[J]. 材料工程, 2019, 47(5): 93-99.
Yan Zhaoming, Zhang Zhimin, Du Yue, et al. Effect of homogenization treatment on microstructure and mechanical properties of Mg-13Gd-3.5Y-2Zn-0.5Zr magnesium alloy[J]. Journal of Materials Engineering, 2019, 47(5): 93-99.