高温形变对精细钢丝用高碳钢盘条珠光体团尺寸的影响

doi:10.13251/j.issn.0254-6051.2024.04.023

金属热处理 ›› 2024, Vol. 49 ›› Issue (4): 146-149.DOI: 10.13251/j.issn.0254-6051.2024.04.023

高温形变对精细钢丝用高碳钢盘条珠光体团尺寸的影响

郭大勇^1,2, 高航^1,2, 潘阳^1,2, 杨迎强³, 王秉喜^1,2, 宫文赫³

1.海洋装备用金属材料及其应用国家重点实验室, 辽宁鞍山 114001;
2.鞍钢集团钢铁研究院, 辽宁鞍山 114001;
3.鞍钢股份有限公司线材厂, 辽宁鞍山 114001

收稿日期:2023-10-10 修回日期:2024-02-23 出版日期:2024-04-25 发布日期:2024-05-27
作者简介:郭大勇(1973—),男,教授级高级工程师, 博士,主要研究方向为线材产品开发,E-mail:dyguo1973@126.com

Effect of high temperature deformation on pearlite colony size in high carbon steel wire rods for fine wires

Guo Dayong^1,2, Gao Hang^1,2, Pan Yang^1,2, Yang Yingqiang³, Wang Bingxi^1,2, Gong Wenhe³

1. State Key Laboratory of Metal Materials for Marine Equipment and Application, Anshan Liaoning 114001, China;
2. Ansteel Iron and Steel Research Institute, Anshan Liaoning 114001, China;
3. Wire Rod Plant of Ansteel, Anshan Liaoning 114001, China

Received:2023-10-10 Revised:2024-02-23 Online:2024-04-25 Published:2024-05-27

摘要/Abstract

摘要： 开展了高温形变对高碳钢盘条珠光体组织转变和珠光体团尺寸影响的试验研究。结果表明,高温形变使珠光体的形核率和长大速率增加,奥氏体向珠光体的转变速率加快。高温形变使试样室温珠光体团细化,珠光体团尺寸分布均匀性得到提升。在形变量分别为20%和40%条件下,相变时间为3 s时,试样的珠光体转变量由不形变条件下的11%增加到32%和53%;试样的珠光体团尺寸由不形变条件下的53.2 μm降低到37.8 μm和23.1 μm,标准差由不形变条件下的29.9 μm降低到11.8 μm和7.9 μm。实际生产可以通过提高轧制速度的方法,细化 LX80A高碳钢盘条的珠光体团,降低盘条珠光体团尺寸分布标准差,从而提高盘条的拉拔性能。

关键词: 高碳钢, 高温形变, 珠光体团, 形核和长大速率

Abstract: Effect of high temperature deformation on the perlite transformation and pearlite colony size was investigated. The results show that high temperature deformation makes both the nucleation and growth rates of pearlite increase, leading to the increase of phase transformation rate from austenite to pearlite. The deformation on austenite also refines the pearlite colony and makes its distribution evenly. The percentage of transformed pearlite is increased from 11% of the specimen without deformation to 32% and 53% of the specimens with 20% and 40% deformations, respectively, when the pearlite transformation time is 3 s. Pearlite colony size is decreased from 53.2 μm of the undeformed specimen to 37.8 μm and 23.1 μm of the specimens with 20% and 40% deformation, standard deviation is also decreased from 29.9 μm of the undeformed specimen to 11.8 μm and 7.9 μm of the deformed specimens. Higher rolling rate can be applied to the industrial production to decrease the pearlite colony size and its standard deviation of the LX80A high carbon steel wire rod in order to improve its drawability.

Key words: high carbon steel, high temperature deformation, pearlite colony, nucleation and growth rates

中图分类号:

TG142.1

郭大勇, 高航, 潘阳, 杨迎强, 王秉喜, 宫文赫. 高温形变对精细钢丝用高碳钢盘条珠光体团尺寸的影响[J]. 金属热处理, 2024, 49(4): 146-149.

Guo Dayong, Gao Hang, Pan Yang, Yang Yingqiang, Wang Bingxi, Gong Wenhe. Effect of high temperature deformation on pearlite colony size in high carbon steel wire rods for fine wires[J]. Heat Treatment of Metals, 2024, 49(4): 146-149.

参考文献

[1]Bhattacharya B, Bhattacharyya T, Haldar A. Influence of microstructure on the mechanical properties of a pearlitic steel[J]. Metallurgical and Materials Transactions A, 2020, 51(7): 3614-3626.
[2]皇祝平, 李解周, 周正东, 等. 82B盘条中心网状渗碳体形成原因及改善措施[J]. 金属制品, 2022, 48(2): 26-29.
Huang Zhuping, Li Jiezhou, Zhou Zhengdong, et al. Formation reason and improvement measure of center network cementite in 82B wire rod[J]. Metal Products, 2022, 48(2): 26-29.
[3]任晨辉, 王伯健. 冷拉珠光体钢丝中渗碳体的溶解行为[J]. 金属热处理, 2011, 36(6): 46-49.
Ren Chenhui, Wang Bojian. Cementite decomposition behaviour during drawing process for pearlitic steel wires[J]. Heat Treatment of Metals, 2011, 36(6): 46-49.
[4]鲁修宇, 刘静, 夏艳花, 等. 热扩散对高碳线材碳偏析和网状渗碳体的影晌[J]. 金属热处理, 2012, 37(3): 62-65.
Lu Xiuyu, Liu Jing, Xia Yanhua, et al. Effect of thermal diffusivity on carbon segregation and cementite net of high carbon wire rod[J]. Heat Treatment of Metals, 2012, 37(3): 62-65.
[5]Oyama T, Sherby O D, Wadsworth J, et al. The role of the divorced eutectoid transformation in the spheroidization of 51200 steel[J]. Metallurgical and Materials Transactions A, 2020, 31(10): 2431-2438.
[6]秦树超, 黄翠环, 赵昊乾, 等. SWRH82B 高碳钢盘条断面收缩率低的机理分析[J]. 金属热处理, 2018, 43(10): 242-246.
Qin Shuchao, Huang Cuihuan, Zhao Haoqian, et al. Mechanism analysis of low percentage of area reduction of SWRH82B high carbon steel wire rod[J]. Heat Treatment of Metals, 2018, 43(10): 242-246.
[7]曾建华, 李义长, 周正. 热轧工艺参数对72LXA钢盘条组织与性能的影响[J]. 金属热处理, 2012, 37(3): 62-65.
Zeng Jianhua, Li Yichang, Zhou Zheng. Effect of hot-rolling parameters on microstructure and mechanical properties of 72LXA steel wire rod[J]. Heat Treatment of Metals, 2012, 37(3): 62-65.
[8]王有铭, 李曼云, 韦光. 钢材的控制轧制和控制冷却[M]. 北京: 冶金工业出版社, 2019.
[9]刘永铨. 钢的热处理[M]. 北京: 冶金工业出版社, 1981.
[10]刘宗昌. 奥氏体形成与珠光体转变[M]. 北京: 冶金工业出版社, 2010.
[11]宋维锡. 金属学[M]. 北京: 冶金工业出版社, 1980.
[12]Reed-Hill R E. Physical Metallurgy Principles[M]. New York: D. Van Nostrand Company, 1964.

[1]	王金涛, 沈奎, 李战卫, 张宇. SWRH82B高碳钢热轧盘条心部组织控制[J]. 金属热处理, 2024, 49(3): 103-107.
[2]	高志喆, 陈小艳, 王永金, 苏盛睿, 陈俊豪, 李佳康, 陈正家. 热处理对复合铸造高铬高碳钢/碳钢耐磨材料微观组织及力学性能的影响[J]. 金属热处理, 2022, 47(8): 163-167.
[3]	冯锐, 李利连, 帖锦芳, 侯嘉强, 米奕媛. 高温形变热处理对20CrMnTiH钢锻件组织及性能的影响[J]. 金属热处理, 2022, 47(3): 72-76.
[4]	卓城之, 高丽, 顾炜华, 雍岐龙, 陆忠. Nb-V微合金化高碳钢在弹性盖板针布用钢丝上的运用[J]. 金属热处理, 2022, 47(1): 69-72.
[5]	吉光, 高秀华, 龙金花. 微合金元素Nb对高碳合金钢动态再结晶行为的影响[J]. 金属热处理, 2021, 46(8): 26-29.
[6]	万志健, 刘学华, 赵海, 江波, 邹强. 钒对高碳珠光体钢组织及拉伸性能的影响[J]. 金属热处理, 2021, 46(3): 140-145.
[7]	顾炜华, 卓城之, 陆忠, 高丽, 张永清, 雍岐龙. 碳含量对铌微合金化高碳钢制金属针布耐磨性的影响[J]. 金属热处理, 2021, 46(12): 72-75.
[8]	笪光杰, 杨忠民, 王凯, 陈颖, 王慧敏, 李少华. 奥氏体化温度和冷却速率对含Nb高碳钢组织性能的影响[J]. 金属热处理, 2020, 45(6): 1-6.
[9]	贺萌, 鲍思前, 赵刚, 张帆, 瞿熙, 黄芳玉. 退火对冷拔高碳钢丝组织及性能的影响[J]. 金属热处理, 2020, 45(11): 144-147.
[10]	孙曼丽1,2，江波1,2，陈刚1,2，杨丽珠1,2，钟斌1,2. Nb微合金化对高碳钢组织和性能的影响[J]. 金属热处理, 2016, 41(4): 71-74.
[11]	熊虎1,梁宇1,2,李静1. 高碳盘条钢等温转变动力学曲线与微观组织[J]. 金属热处理, 2016, 41(12): 5-9.
[12]	王奇1,2，李晓源2，时捷2,杨西荣1,余斌2[收稿日期：2016-06-12. 球化退火等温温度对高碳钢组织的影响[J]. 金属热处理, 2016, 41(11): 88-92.
[13]	余斌1,2, 李晓源2, 时捷2,黎振华1, 胡俊2. 等温球化退火工艺对高碳钢碳化物球化的影响[J]. 金属热处理, 2016, 41(1): 91-93.
[14]	高航1，任玉辉2，郭大勇1，王秉喜1，张博1，马立国1，车安2，郭晓波1. 扩散退火降低高碳钢偏析的研究[J]. 金属热处理, 2015, 40(8): 146-149.
[15]	廖舒纶，沈奎，于学森，麻晗. Nb含量对高碳钢相转变的影响[J]. 金属热处理, 2015, 40(4): 45-49.

高温形变对精细钢丝用高碳钢盘条珠光体团尺寸的影响

Effect of high temperature deformation on pearlite colony size in high carbon steel wire rods for fine wires

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价