Mg-Gd-Zn-Zr镁合金的摩擦磨损行为

doi:10.13251/j.issn.0254-6051.2024.11.004

摘要/Abstract

摘要： 利用光学显微镜、扫描电镜、能谱仪、显微硬度计和摩擦磨损试验机研究了不同Gd含量的固溶态Mg-xGd-1Zn-0.4Zr(x=3,6,9 wt%)合金和不同Zn含量的固溶态Mg-6Gd-yZn-0.4Zr(y=0.5,1,2 wt%)合金的显微组织、硬度、摩擦因数、磨损率和磨损形貌。结果表明,随着Gd或Zn含量的增加,固溶态合金的晶粒有所细化,合金的硬度上升,摩擦因数变化较小。随着Gd含量的增加,合金的磨损率稍有增加;而随着Zn含量的升高,合金的磨损率降低,当Zn含量为2%时,其磨损率比Zn含量为0.5%合金的磨损率降低了24%。5组合金主要发生了磨粒磨损、氧化磨损和塑性变形。当Gd含量为9%时,还观察到粘着磨损。Mg-Gd-Zn-Zr合金的耐磨性主要取决于磨损机制,与硬度无直接对应关系。

关键词: Mg-Gd-Zn-Zr镁合金, 摩擦因数, 磨损率, 磨损机制

Abstract: Microstructure, microhardness, friction coefficient, wear rate and worn surface morphology of solution treated Mg-xGd-1Zn-0.4Zr (x=3, 6, 9 wt%) alloys with different Gd contents and solution treated Mg-6Gd-yZn-0.4Zr (y=0.5, 1, 2 wt%) alloys with various Zn additions were studied by means of optical microscope, scanning electron microscope, energy spectrometer, microhardness tester and friction and wear testing machine. The results show that the grains refine, the microhardness increases, and the friction coefficient shows slight change with Gd or Zn content increasing. The wear rate of the alloys increases slightly with the increase of Gd content, whereas, it decreases with the increase of Zn content. Compared with the alloy containing 0.5%Zn, the wear rate of the alloy containing 2%Zn presents 24% reduction. The main wear mechanisms of the five alloys are abrasion, oxidation and plastic deformation, as well as adhesion for the alloy containing 9%Gd. The wear resistance of the alloys depends on the wear mechanisms and has no direct relation to the hardness.

Key words: Mg-Gd-Zn-Zr magnesium alloys, friction coefficient, wear rate, wear mechanism

中图分类号:

TG146.2

王若天, 朱帅帅. Mg-Gd-Zn-Zr镁合金的摩擦磨损行为[J]. 金属热处理, 2024, 49(11): 23-28.

Wang Ruotian, Zhu Shuaishuai. Tribological behavior of Mg-Gd-Zn-Zr magnesium alloys[J]. Heat Treatment of Metals, 2024, 49(11): 23-28.

参考文献

[1]汪荣香, 洪立鑫, 章晓波. 生物医用镁合金耐腐蚀性能研究进展[J]. 材料工程, 2021, 49(12): 14-27.
Wang Rongxiang, Hong Lixin, Zhang Xiaobo. Research progress in corrosion resistance of biomedical magnesium alloys[J]. Journal of Materials Engineering, 2021, 49(12): 14-27.
[2]冀盛亚, 常成, 常帅兵, 等. 医用镁合金植入材料的发展策略及演进趋势[J]. 材料工程, 2023, 51(7): 89-101.
Ji Shengya, Chang Cheng, Chang Shuaibing, et al. Development strategy and trend of medical magnesium alloy implant materials[J]. Journal of Materials Engineering, 2023, 51(7): 89-101.
[3]Niranjan C A, Raghavendra T, Madhuri P R, et al. Magnesium alloys as extremely promising alternatives for temporary orthopedic implants-A review[J]. Journal of Magnesium and Alloys, 2023, 11(8): 2688-2718.
[4]Yang Lixiang, Huang Yuanding, Hou Zhengquan, et al. Microstructure, mechanical properties and fracture behaviors of large-scale sand-cast Mg-3Y-2Gd-1Nd-0. 4Zr alloy[J]. Journal of Magnesium and Alloys, 2023, 11(8): 2763-2775.
[5]万超, 郝智秀, 温诗铸. 骨科植入物的微动摩擦学研究现状及进展[J]. 摩擦学学报, 2012, 32(1): 102-112.
Wan Chao, Hao Zhixiu, Wen Shizhu. Research and prospect on the fretting tribology of the orthopedic implants[J]. Tribology, 2012, 32(1): 102-112.
[6]李庆芬, 邓彬, 吴远志, 等. 轧制温度对AZ31镁合金组织与耐磨性的影响[J]. 金属热处理, 2023, 48(6): 58-62.
Li Qinfen, Deng Bin, Wu Zhiyuan, et al. Effect of rolling temperature on microstructure and wear resistance of AZ31 magnesium alloy[J]. Heat Treatment of Metals, 2023, 48(6): 58-62.
[7]Shen Yongshui, Sun Tongjin, Zhu Tao, et al. Corrosive-wear behavior of LSP/MAO treated magnesium alloys in physiological environment with three pH values[J]. Corrosion Reviews, 2022, 40(1): 65-76.
[8]夏双五, 侯义勇, 张红云, 等. 镁合金摩擦磨损性能的研究进展[J]. 兵器材料科学与工程, 2020, 43(4): 130-134.
Xia Shuangwu, Hou Yiyong, Zhang Hongyun, et al. Research progress in friction and wear behaviors of Mg alloy[J]. Ordnance Material Science and Engineering, 2020, 43(4): 130-134.
[9]Zhu Tao, Yu Yi, Shen Yongshui, et al. Wear behavior of extruded ZK60 magnesium alloy in simulated body fluid with different pH values[J]. Materials Chemistry and Physics, 2021, 262: 124292.
[10]Su Jinlong, Teng Jie, Xu Zili, et al. Corrosion-wear behavior of a biocompatible magnesium matrix composite in simulated body fluid[J]. Friction, 2022, 10: 31-43.
[11]Zhang Jie, Zhang Xiaobo, Liu Qinghua, et al. Effects of load on dry sliding wear behavior of Mg-Gd-Zn-Zr alloys[J]. Journal of Materials Science & Technology, 2017, 33(7): 645-651.
[12]Peng Jinfang, Tang Yijuan, Li Bo, et al. Investigation of corrosion-time effects on fretting wear behaviours of copper-magnesium alloy[J]. Wear, 2023, 512: 204549.
[13]Dai Jianwei, Zhang Xiaobo, Yin Qiao, et al. Friction and wear behaviors of biodegradable Mg-6Gd-0.5Zn-0.4Zr alloy under simulated body fluid condition[J]. Journal of Magnesium and Alloys, 2017, 5(4): 448-453.
[14]Zhao Li, Chen Wei, Dai Jianwei, et al. Effects of heat treatment on corrosion and wear behaviors of Mg-6Gd-2Zn-0.4Zr alloy in simulated body fluid[J]. Journal of Materials Engineering and Performance, 2017, 26(11): 5501-5510.
[15]Zhang Xiaobo, Wu Yujuan, Xue Yajun, et al. Biocorrosion behavior and cytotoxicity of a Mg-Gd-Zn-Zr alloy with long period stacking ordered structure[J]. Materials Letters, 2012, 86: 42-45.
[16]Zhang Xiaobo, Dai Jianwei, Zhang Jie, et al. Quantitative evaluation of the interaction between wear and corrosion on Mg-3Gd-1Zn alloy in simulated body fluid[J]. Journal of Materials Engineering and Performance, 2019, 28: 355-362.
[17]Zhang Xiaobo, Ba Zhixin, Wang Zhangzhong, et al. Microstructure and corrosion behavior of biodegradable Mg-6Gd-xZn-0.4Zr alloys with and without long period stacking ordered structure[J]. Corrosion Science, 2016, 105: 68-77.
[18]Abdelgnei M A, Omar M Z, Ghazali M J, et al. Dry sliding wear behaviour of thixoformed Al-5.7Si-2Cu-0.3Mg alloys at high temperatures using Taguchi method[J]. Wear, 2020, 442: 203134.
[19]刘文林, 靳宇斐, 韩宇翔, 等. 大型镁合金锥形壳体显微组织与力学性能不均匀性[J]. 中国有色金属学报, 2022, 32(9): 2521-2532.
Liu Wenlin, Jin Yufei, Han Yuxiang, et al. Inhomogeneity of microstructure and mechanical property of large magnesium alloy conical shell[J]. The Chinese Journal of Nonferrous Metals, 2022, 32(9): 2521-2532.
[20]Turan M E, Zengin H, Sun Y. Dry sliding wear behavior of (MWCNT+GNPs) reinforced AZ91 magnesium matrix hybrid composites[J]. Metals and Materials International, 2020, 26: 541-550.
[21]Patil A, Bontha S, Ramesh M R. Effect of ECAP on sliding wear behaviour of Mg-Zn-Gd-Zr alloy[J]. Materials Today: Proceedings, 2020, 20: 97-102.
[22]Barylski A, Aniołek K, Dercz G, et al. The sclerometrical, mechanical, and wear behavior of Mg-Y-Nd magnesium alloy after deep cryogenic treatment combined with heat treatment[J]. Materials, 2021, 14(5): 1218.
[23]Mansouri A, Ghasemi H M, Yazdi R, et al. Dry tribological behavior of a cast Mg-Gd-Zr-Ag alloy at room and elevated temperatures[J]. Journal of Materials Research and Technology, 2022, 18: 5126-5143.
[24]Kumar K K A, Pillai U T S, Pai B C, et al. Dry sliding wear behaviour of Mg-Si alloys[J]. Wear, 2013, 303(1/2): 56-64.
[25]Kim Y, Mishra R K, Sachdev A K, et al. A combined experimental-analytical modeling study of the artificial aging response of Al-Mg-Si alloys[J]. Materials Science and Engineering A, 2021, 820: 141566.