返红温度对低屈强比高强度耐火耐候钢组织及性能的影响

doi:10.13251/j.issn.0254-6051.2020.06.008

金属热处理 ›› 2020, Vol. 45 ›› Issue (6): 39-42.DOI: 10.13251/j.issn.0254-6051.2020.06.008

返红温度对低屈强比高强度耐火耐候钢组织及性能的影响

林田子, 侯华兴, 杨颖, 张涛, 张哲, 纪汶伯

鞍钢集团钢铁研究院, 辽宁鞍山 114009

收稿日期:2019-11-02 出版日期:2020-06-25 发布日期:2020-09-02
作者简介:林田子(1987—),男,高级工程师,硕士,主要研究方向为高性能建筑及桥梁结构用钢,E-mail: aglintianzi@163.com
基金资助:
国家重点研发计划(2017YFB0304700)

Effect of self-tempering temperature on microstructure and properties of high strength fire-resistant and weathering construction steel with low yield ratio

Lin Tianzi, Hou Huaxing, Yang Ying, Zhang Tao, Zhang Zhe, Ji Wenbo

Iron & Steel Research Institutes of Ansteel Group Corporation, Anshan Liaoning 114009, China

Received:2019-11-02 Online:2020-06-25 Published:2020-09-02

摘要/Abstract

摘要： 采用光学显微镜(OM)、扫描电镜(SEM)、透射电镜(TEM)等方法对不同返红温度下的低屈强比高强度耐火耐候钢的微观组织及力学性能进行了研究与分析。结果表明:当钢板水冷后的返红温度从550 ℃下降至350 ℃时,试验钢显微组织由铁素体和少量贝氏体逐渐转变为由板条贝氏体和弥散细小的M-A岛组成的复相组织结构,贝氏体板条尺寸进一步细化,钢板的屈服强度、屈强比明显升高,抗拉强度变化不大,断后伸长率降低。在返红温度为450~500 ℃范围内试验钢具有较低的屈强比和更优异的强韧性匹配。

关键词: 高强度耐火耐候钢, 返红温度, 组织, 性能, 低屈强比

Abstract: Microstructure and properties of high strength fire-resistant and weathering construction steel with low yield ratio at different self-tempering temperatures were studied by OM, SEM and TEM. The results show that when the self-tempering temperature of the steel plate after water cooling is decreased from 550 ℃ to 350 ℃, the microstructure of the tested steel gradually changes from ferrite and a small amount of bainite to multiphase structure consisting of lath bainite and dispersed fine M-A islands. The size of bainite lath is further refined, the yield strength and yield ratio of the steel plate increase obviously, the tensile strength does not change much, and the percentage elongation after fracture decreases. When the self-tempering temperature is within the range of 450-500 ℃, the tested steel has lower yield ratio and better strength-toughness matching.

Key words: high strength fire-resistant and weathering construction steel, self-tempering temperature, microstructure, properties, low yield ratio

中图分类号:

TG142.1

林田子, 侯华兴, 杨颖, 张涛, 张哲, 纪汶伯. 返红温度对低屈强比高强度耐火耐候钢组织及性能的影响[J]. 金属热处理, 2020, 45(6): 39-42.

Lin Tianzi, Hou Huaxing, Yang Ying, Zhang Tao, Zhang Zhe, Ji Wenbo. Effect of self-tempering temperature on microstructure and properties of high strength fire-resistant and weathering construction steel with low yield ratio[J]. Heat Treatment of Metals, 2020, 45(6): 39-42.

参考文献

[1]Tang Z H, Stumpf W. The effect of microstructure and processing variables on the yield to ultimate tensile strength ratio in a Nb-Ti and a Nb-Ti-Mo line pipe steel[J]. Material Science and Engineering A, 2008, 490: 391-402.
[2]唐帅, 刘振宇, 王国栋, 等. 高层建筑用钢板的生产现状及发展趋势[J]. 钢铁研究学报, 2010, 22(10): 1-6.
Tang Shuai, Liu Zhenyu , Wang Guodong, et al. Present situation and developing tendency of steel plates for high-rise constructional steel[J]. Journal of Iron and Steel Research, 2010, 22(10): 1-6.
[3]韩孝永. 高层建筑结构用钢浅析[J]. 梅山科技, 2008(1): 45-47.
Han Xiaoyong. Brief analysis on high rise building structure steel[J]. Baosteel Meishan, 2008(1): 45-47.
[4]Eda K, Endo S, Ito T. 780 MPa grade steel plates with low yield ratio by microstructural control of dual phase[J]. JFE Technical Report, 2007, 18: 23-28.
[5]姚连登, 焦胜利, 赵小婷. 800 MPa级双相组织低屈服比钢厚板试制[J]. 钢铁钒钛, 2007, 28(2): 37-42.
Yao Liandeng, Jiao Shengli, Zhao Xiaoting. Development of 800 MPa low yield ratio heavy plate with dual phase[J]. Iron Steel Vanadium Titanium, 2007, 28(2): 37-42.
[6]于庆波, 孙莹, 黄传辉, 等. 屈强比对塑性影响的研究[J]. 塑性工程学报, 2009, 16(1): 153-156.
Yu Qingbo, Sun Ying, Huang Chuanhui, et al. Research of yield-strength ratio on the plasticity[J]. Journal of Plasticity Engineering, 2009, 16(1): 153-156.
[7]康健, 周晓光, 王国栋. 高强度低屈强比建筑用钢板的研究开发[J]. 轧钢, 2009, 26(3): 31-35.
Kang Jian, Zhou Xiaoguang, Wang Guodong. Development of high strength and low yield ratio steel plates for buildings[J]. Steel Rolling, 2009, 26(3): 31-35.
[8]阴树标, 刘清友, 张志波, 等. 热变形参数对含铌钢奥氏体未再结晶区变形相变的影响[J]. 钢铁, 2008, 43(2): 81-85.
Yin Shubiao, Liu Qingyou, Zhang Zhibo, et al. Effect of hot deformation parameters on phase transformation in austenite non-recrystallization region of niobium steel[J]. Iron and Steel, 2008, 43(2): 81-85.
[9]贾志鑫, 衣海龙, 刘嵩韬, 等. 控轧控冷参数对含铌微合金钢组织的影响[J]. 机械工程材料, 2006, 30(9): 6-7.
Jia Zhixin, Yi Hailong, Liu Songtao, et al. Effect of controlled rolling and cooling parameters on structure of niobium microalloyed steel[J]. Materials for Mechanical Eegineering, 2006, 30(9): 6-7.
[10]Gomez M, Medina S F, Quispe A, et al. Static recrystallization and induce precipitation in a low Nb microalloyed steel[J]. ISIJ International, 2002, 42(4): 422-423.
[11]王有铭, 李曼云, 韦光. 钢材的控制轧制和控制冷却[M]. 北京: 冶金工业出版社, 2007.
Wang Youming, Li Manyun, Wei Guang. Controlled Rolling and Cooling of Steel[M]. Beijing: Metallurgical Industry Press, 2007.
[12]孙昊, 赵风光, 王海燕, 等. 终冷温度对X80管线钢DWTT性能影响的研究[J]. 热加工工艺, 2013, 42(1): 32-34.
Sun Hao, Zhao Fengguang, Wang Haiyan, et al. Effect of final cooling temperature on DWTT properties of X80 pipeline steel[J]. Hot Working Technology, 2013, 42(1): 32-34.

[1]	王玉岱, 刘洋, 朱言言, 田象军, 程序, 冉先喆, 钱婷婷. 热处理对复合制造AerMet100超高强度钢组织均匀性与拉伸性能的影响[J]. 金属热处理, 2022, 47(4): 1-9.
[2]	张子延, 陈君, 陈晓亚, 李全安, 刘建鑫. 固溶时效处理对Mg-4Sm-3Gd-0.5Zr合金显微组织和耐蚀性能的影响[J]. 金属热处理, 2022, 47(4): 10-16.
[3]	梁恩溥, 徐乐, 杨勇, 王毛球. 添加Al、Cu对40CrNi3MoV钢组织和力学性能的影响[J]. 金属热处理, 2022, 47(4): 17-23.
[4]	祁晓亮, 李岩, 定巍, 赵增武. 含Al中锰TRIP钢原始组织对临界退火后组织与力学性能的影响[J]. 金属热处理, 2022, 47(4): 24-29.
[5]	陈保安, 张静媛, 祝志祥, 韩钰, 潘学东, 张磊, 陈素红. 化学成分对高强Al-Mg-Si合金组织和性能的影响[J]. 金属热处理, 2022, 47(4): 30-38.
[6]	陈东俊, 李广阳, 刘刚. 时效处理对AlSi9Cu3压铸铝合金组织和力学性能的影响[J]. 金属热处理, 2022, 47(4): 53-56.
[7]	陈连生, 张露友, 田亚强, 杨子旋, 李红斌, 潘红波, 魏英立. 低碳高强舰船用钢的CCT曲线及其组织性能[J]. 金属热处理, 2022, 47(4): 63-68.
[8]	贾昌远, 霍元明, 何涛, 霍存龙, 刘克然. 40CrNiMo钢高温拉伸变形行为和组织演变规律[J]. 金属热处理, 2022, 47(4): 69-74.
[9]	王云龙, 余伟, 张昳, 史佳新, 李明辉. 奥氏体化温度对贝氏体钢等温转变及力学性能的影响[J]. 金属热处理, 2022, 47(4): 80-85.
[10]	陈思君, 陈送义, 陈庚, 袁丁玲, 陈康华. Mg含量对2A14铝合金组织和力学性能的影响[J]. 金属热处理, 2022, 47(4): 86-92.
[11]	刘丽艳, 毕文珍, 韦习成. Mn元素对热冲压钢镀锌层组织演变的影响[J]. 金属热处理, 2022, 47(4): 93-99.
[12]	骆再斌, 范子泽, 彭振. 轻质高熵合金的研究进展[J]. 金属热处理, 2022, 47(4): 100-107.
[13]	白青青, 张志宏, 郑淮北, 王英虎. 2507超级双相不锈钢中σ相的析出行为[J]. 金属热处理, 2022, 47(4): 108-115.
[14]	陈刚, 罗小兵, 柴锋, 杨才福, 张正延, 杨丽. 轧制加热温度对高强度低合金钢组织及冲击性能的影响[J]. 金属热处理, 2022, 47(4): 116-121.
[15]	付锡彬, 陈子豪, 张可, 赵时雨, 孙新军, 朱正海, 梁小凯, 雍岐龙. 淬火温度对高Ti低合金耐磨钢组织及力学性能的影响[J]. 金属热处理, 2022, 47(4): 122-127.

返红温度对低屈强比高强度耐火耐候钢组织及性能的影响

Effect of self-tempering temperature on microstructure and properties of high strength fire-resistant and weathering construction steel with low yield ratio

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价