初始组织对20CrMnTi钢伪渗碳过程中奥氏体化相变与晶粒长大行为的影响

doi:10.13251/j.issn.0254-6051.2020.06.033

金属热处理 ›› 2020, Vol. 45 ›› Issue (6): 157-162.DOI: 10.13251/j.issn.0254-6051.2020.06.033

初始组织对20CrMnTi钢伪渗碳过程中奥氏体化相变与晶粒长大行为的影响

李俊¹, 黄健², 贾涛²

1. 山西太钢不锈钢股份有限公司技术中心, 山西太原 030003;
2. 东北大学轧制技术及连轧自动化国家重点实验室, 辽宁沈阳 110819

收稿日期:2020-03-15 出版日期:2020-06-25 发布日期:2020-09-02
通讯作者: 贾涛,副教授,E-mail: jiatao@ral.neu.edu.cn
作者简介:李俊(1978—), 男, 高级工程师,硕士, E-mail: lijun2@tisco.com.cn。
基金资助:
国家重点研发计划(2017YFB0304201)

Effect of initial microstructure on austenite transformation and grain growth behavior of 20CrMnTi steel during pseudo-carburizing process

Li Jun¹, Huang Jian², Jia Tao²

1. Technical Center, Shanxi TISCO Stainless Steel Co., Ltd., Taiyuan Shanxi 030003, China;
2. The State Key Lab of Rolling and Automation, Northeastern University, Shenyang Liaoning 110819, China

Received:2020-03-15 Online:2020-06-25 Published:2020-09-02

摘要/Abstract

摘要： 研究了20CrMnTi钢球化退火过程中的渗碳体析出行为及其与铁素体回复和再结晶的相互作用,着重分析了热轧态、淬火态和球化态3种初始组织在伪渗碳过程中的奥氏体化相变与晶粒长大行为。结果表明,热轧态和淬火态试样分别具有均匀粗大的“铁素体+珠光体”组织和均匀细化的马氏体板条组织;在球化态试样中,由于球化时碳化物析出与马氏体基体回复、再结晶的相互作用,基体组织与碳化物均存在微观非均匀现象。经伪渗碳后,奥氏体平均晶粒尺寸按热轧态、淬火态和球化态次序依次减小,但不均匀性因子按该次序依次增大;与初始组织相关的奥氏体形核密度与形核均匀性是控制渗碳过程中奥氏体晶粒长大行为的关键因素之一。

关键词: 20CrMnTi钢, 渗碳, 初始组织, 奥氏体化相变, 晶粒长大

Abstract: The cementite precipitation behavior of 20CrMnTi steel during spheroidizing annealing and its interaction with ferrite recovery and recrystallization were studied, and the effects of initial microstructure as-in hot-rolled state, quenched state and spheroidizing annealed state on austenite transformation and grain growth behavior during pseudo-carburizing were emphatically analyzed. The results show that coarse ferrite + pearlite microstructure and uniform fine lath martensite microstructure can be found in the hot-rolled and quenched specimens, respectively. However, the matrix and the carbide microstructures in the spheroidized specimens are nonuniform in micro-scale due to the interaction of carbide precipitating with recovery, recrystallization of martensite matrix. During pseudo-carburizing, the average grain size of austenite decreases in the order of hot rolled state, quenched state and spheroidizing annealed state, but the non-uniformity factor increases in the same order. The nucleation density and homogeneity of austenite related to the initial microstructure are one of the key factors controlling the austenite grain growth behavior during carburizing.

Key words: 20CrMnTi steel, carburizing, initial microstructure, austenite transformation, grain growth

中图分类号:

TG156.8⁺1

李俊, 黄健, 贾涛. 初始组织对20CrMnTi钢伪渗碳过程中奥氏体化相变与晶粒长大行为的影响[J]. 金属热处理, 2020, 45(6): 157-162.

Li Jun, Huang Jian, Jia Tao. Effect of initial microstructure on austenite transformation and grain growth behavior of 20CrMnTi steel during pseudo-carburizing process[J]. Heat Treatment of Metals, 2020, 45(6): 157-162.

参考文献

[1]安金敏, 覃明, 丁毅. 奥氏体晶粒度对汽车齿轮钢热处理畸变的影响[J]. 热处理, 2013, 28(3): 48-51.An Jinmin, Qin Min, Ding Yi. Effect of austenite grain size on heat treatment distortion automotive gear steels[J]. Heat Treatment, 2013, 28(3): 48-51.
[2]Matlock D K, Alogab K A, Richards M D. Surface processing to improve the fatigue resistance of advanced bar steels for automotive applications[J]. Materials Research, 2005, 8(4): 453-459.
[3]Kubota M, Ochi T. Development of anti-coarsening steel for carburizing[J]. Materials Science Forum, 2007, 539-543: 4855-4860.
[4]Tanaka T, Fujimatsu T, Hashimoto K, et al. Austenite grain stability of titanium-modified carburizing steel[J]. Solid State Phenomena, 2006, 118: 3-8.
[5]Alogab K A, Matlock D K, Speer J G, et al. The effects of heating rate on austenite grain growth in a Ti-modified SAE 8620 steel with controlled niobium additions[J]. ISIJ International, 2007, 47(7): 1034-1041.
[6]Kinoshita S, Ueda T, Suzuki A. Behavior of aluminum nitride austenite grain size and its coarsening temperature in low alloy steels[J]. Tetsu-to-Hagane, 1973, 59(3): 446-453.
[7]毛卫民. 金属的再结晶与晶粒长大[M]. 北京: 冶金工业出版社, 1994: 218-219.
[8]Novikov V Y. Microstructure evolution during grain growth in materials with disperse particles[J]. Materials Letters, 2012, 68: 413-415.
[9]Song W W, Choi P, Inden G, et al. On the spheroidized carbide dissolution and elemental partitioning in high carbon bearing steel 100Cr6[J]. Metallurgical and Materials Transactions A, 2014, 45(2): 595-606.
[10]Zurob H S, Hutchinson C R, Béché A, et al. A transition from local equilibrium to paraequilibrium kinetics for ferrite growth in Fe-C-Mn: A possible role of interfacial segregation[J], Acta Materialia, 2008, 56(10): 2203-2211.
[11]陈浩, 张璁雨, 朱加宁, 等, 奥氏体/铁素体界面迁移与元素配分的研究进展[J]. 金属学报, 2018, 54(2): 217-227.
Chen Hao, Zhang Congyu, Zhu Jianing, et al. Austenite/ferrite interface migration and alloying elements partitioning: An overview[J]. Acta Metallurgica Sinica, 2018, 54(2): 217-227.
[12]雍岐龙. 钢铁材料中的第二相[M]. 北京: 冶金工业出版社, 2006: 49-51.
[13]Gladman T. On the theory of the effect of precipitate particles on grain growth in metals[J]. Proceedings of the Royal Society of London. Series A. Mathematical and Physical Sciences, 1966, 294(1438): 298-309.

[1]	章建军, 庄晓伟, 汤晓峰. 提高低碳钢磁性能的球化退火工艺试验[J]. 金属热处理, 2022, 47(4): 182-184.
[2]	戴建科, 韩顺, 厉勇, 刘宪民, 王春旭, 庞学东, 李建新. 航空齿轮钢C69高温渗碳后的组织性能[J]. 金属热处理, 2022, 47(4): 219-225.
[3]	陈强, 陈林芳, 杨明华. 18CrNiMo7-6钢的可控气氛高温渗碳工艺[J]. 金属热处理, 2022, 47(4): 231-239.
[4]	杨劼, 任慧平, 刘宗昌. 15Cr12CuSiMoMn钢的奥氏体晶粒长大动力学[J]. 金属热处理, 2022, 47(2): 53-58.
[5]	卢锐, 柯文敏, 况侨, 饶良斌, 丁琪, 陆金香. 航空发动机16Ni3CrMoE钢制输出轴的热处理畸变控制[J]. 金属热处理, 2022, 47(2): 168-172.
[6]	王自敏, 杨志强, 胡芳忠, 汪开忠, 丁雷. Nb微合金化对18CrNiMo7-6钢奥氏体晶粒长大的影响[J]. 金属热处理, 2021, 46(9): 53-57.
[7]	秦春, 李宁, 董福元, 李涌泉. Ti-22Al-27Nb合金的晶粒长大行为[J]. 金属热处理, 2021, 46(8): 42-45.
[8]	赵阳磊, 王灵水, 邱胜闻, 董升朝, 陈利阳. 60Si2Mn弹簧钢退火过程中的组织与性能变化[J]. 金属热处理, 2021, 46(8): 180-183.
[9]	许鸿翔, 王红伟, 张衡, 汪军, 赵少甫. 20Cr2Ni4钢齿轮渗碳淬火及装配后开裂原因分析[J]. 金属热处理, 2021, 46(8): 250-253.
[10]	赵少甫, 许鸿翔, 王红伟, 郭敬强, 李子岩, 陈岩. 提高20Cr2Ni4A钢齿轮渗碳淬火硬度的试验研究[J]. 金属热处理, 2021, 46(7): 120-125.
[11]	罗建东, 杨颖仪, 林育周. 离子扩渗工艺对316L不锈钢表层组织及磁性能的影响[J]. 金属热处理, 2021, 46(7): 207-211.
[12]	易华清, 刘克, 苏震, 杨兵, 舒兵, 罗子相. BH复合催渗程控系统的构建及数值模拟[J]. 金属热处理, 2021, 46(7): 212-217.
[13]	阎勇, 卜恒勇, 李萌蘖, 郑善举. S34MnV钢的奥氏体晶粒长大动力学[J]. 金属热处理, 2021, 46(6): 153-159.
[14]	彭则, 李萌蘖, 卜恒勇, 李其. 42CrMo钢加热过程中的奥氏体晶粒尺寸演变[J]. 金属热处理, 2021, 46(5): 25-31.
[15]	刘克, 杨兵, 孙林, 欧阳雪枚, 丁卉, 朱旭. BH催渗工艺对12CrNi3渗碳钢组织和性能的影响[J]. 金属热处理, 2021, 46(4): 171-175.

初始组织对20CrMnTi钢伪渗碳过程中奥氏体化相变与晶粒长大行为的影响

Effect of initial microstructure on austenite transformation and grain growth behavior of 20CrMnTi steel during pseudo-carburizing process

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

本文评价