气垫炉中铜带材漂浮行为的数值模拟

doi:10.13251/j.issn.0254-6051.2023.12.044

金属热处理 ›› 2023, Vol. 48 ›› Issue (12): 269-276.DOI: 10.13251/j.issn.0254-6051.2023.12.044

气垫炉中铜带材漂浮行为的数值模拟

赵鹏, 李家栋, 李勇

东北大学轧制技术及连轧自动化国家重点实验室, 辽宁沈阳 110819

收稿日期:2023-08-01 修回日期:2023-09-29 出版日期:2023-12-25 发布日期:2024-01-29
通讯作者: 李家栋,副教授,博士,E-mail:lijiadongvip@qq.com
作者简介:赵鹏(1997—),男,硕士研究生,主要研究方向为气垫炉漂浮问题模拟和试验验证,E-mail:2070592@stu.neu.edu.cn。
基金资助:
山东省重点研发计划(2019JZZY010401);南宁市科技重大专项(20201041)

Numerical simulation on floating behavior of copper strip in air cushion furnace

Zhao Peng, Li Jiadong, Li Yong

State Key Laboratory of Rolling Technology and Continuous Rolling Automation, Northeastern University, Shenyang Liaoning 110819, China

Received:2023-08-01 Revised:2023-09-29 Online:2023-12-25 Published:2024-01-29

摘要/Abstract

摘要： 基于东北大学轧制技术及连轧自动化国家重点实验室中试气垫炉的试验数据和几何模型,采用Ansys Fluent软件构建了气垫炉漂浮仿真模拟平台,分析了气垫炉入口风量、带材漂浮高度、流体温度和喷嘴结构对铜带材漂浮行为的影响。结果表明,带材漂浮高度在H=80~180 mm范围内有利于带材稳定漂浮;温度越高,带材所受压力降低,增大入口风量对压力的提升效果减弱;高温条件下,出现风机功率波动时对带材压力影响较小,有利于带材稳定漂浮;狭缝喷嘴倾斜角度由30°优化为60°有利于改善带材压力分布均匀性,但会降低带材所受压力。

关键词: 气垫炉, 铜带材, 漂浮过程, 有限元模拟, 喷嘴结构

Abstract: Based on the experimental data and geometric model for the experimental air cushion furnace from the State Key Laboratory of Rolling Technology and Continuous Rolling Automation of Northeastern University, the Ansys Fluent software was used to construct the air cushion furnace floating simulation platform, and the effects of air cushion furnace inlet air volume, strip floating height, fluid temperature and nozzle structure on the copper strip floating behavior were analyzed. The results show that the floating height of the strip is conducive to the stable floating of the strip in the range of H=80-180mm. The higher the temperature, the lower the pressure of the strip, and the increase in the inlet air volume weakens the pressure lifting effect. Under high temperature conditions, the possible fan power fluctuations have little effect on the strip pressure, which is conducive to stable floating of the strip. The optimized inclination angle of the slit nozzle from 30° to 60° is conducive to improving the uniformity of strip pressure distribution, but will reduce the pressure on the strip.

Key words: air cushion furnace, copper strip, flotation process, finite element simulation, nozzle structure

中图分类号:

TG155

赵鹏, 李家栋, 李勇. 气垫炉中铜带材漂浮行为的数值模拟[J]. 金属热处理, 2023, 48(12): 269-276.

Zhao Peng, Li Jiadong, Li Yong. Numerical simulation on floating behavior of copper strip in air cushion furnace[J]. Heat Treatment of Metals, 2023, 48(12): 269-276.

参考文献

[1]张青科, 刘峰, 冯小龙, 等. 高精密蚀刻引线框架用铜合金板带性能要求于发展展望[J]. 热加工工艺, 2020, 49(20): 6-9, 14.
Zhang Qingke, Liu Feng, Feng Xiaolong, et al. Performance requirements and development prospect of Cu alloy strip for high precision etching lead frame[J]. Hot Working Technology, 2020, 49(20): 6-9, 14.
[2]张专利. 压延铜箔发展现状及市场分析[J]. 有色冶金设计与研究, 2015, 36(4): 36-39, 42.
Zhang Zhuanli. Development status and market analysis on rolled copper foil[J]. Nonferrous Metals Engineering and Research, 2015, 36(4): 36-39, 42.
[3]李勇, 王昭东, 马鸣图, 等. 高品质铝合金汽车板预处理气垫炉技术[J]. 中国工程科学, 2014, 16(1): 14-22, 2.
Li Yong, Wang Zhaodong, Ma Mingtu, et al. Review and prospect of the air cushion furnace technology for aluminum alloy automotive sheet pre-treatment[J]. Engineering Sciences, 2014, 16(1): 14-22, 2.
[4]陈文修, 何英和, 刘非轼, 等. 气垫式金属板带材连续热处理炉内气体动力过程的研究[J]. 中南矿冶金学院学报, 1987(2): 31-36, 116.
[5]Hornig K, Blling R, Odenthal H J, et al. Simulation of fluid flow and strip stability in a strip floatation furnace by physical and numerical methods[C]// 6th Thermoprocess Conference, 2003: 1-18.
[6]Chang Y B, Moretti P M. Aerodynamic characteristics of pressure-pad air bars[J]. Journal of Applied Mechanics, 2000, 67(1): 177-182.
[7]Ozmen Y. Confined impinging twin air jets at high Reynolds numbers[J]. Experimental Thermal and Fluid Science, 2011, 35(2): 355-363.
[8]Abdel-Fattah. Numerical and experimental study of turbulent impinging twin-jet flow[J]. Experimental Thermal and Fluid Science, 2007, 31(8): 1061-1072.
[9]Attalla M, Maghrabie H M, Specht E. Effect of inclination angle of a pair of air jets on heat transfer into the flat surface[J]. Experimental Thermal and Fluid Science, 2017, 85: 85-94.
[10]Miao J M, Wu C Y, Chen P H. Numerical investigation of confined multiple-jet impingement cooling over a flat plate at different crossflow orientaions[J]. Numerical Heat Transfer, 2009, 55(11): 1019-1050.
[11]Baydar E, Ozmen Y. An experimental investigation on flow structures of confined and unconfined impinging air jets[J]. Heat and Mass Transfer, 2005, 42(4): 338-346.
[12]Afroz F, Sharif M A R. Numerical study of heat transfer from an isothermally heated flat surface due to turbulent twin oblique confined slot-jet impingement[J]. International Journal of Thermal Sciences, 2013, 74: 1-13.
[13]Öztekin E, Aydin O, Avcı M. Hydrodynamics of a turbulent slot jet flow impinging on a concave surface[J]. International Communications in Heat and Mass Transfer, 2012, 39(10): 1631-1638.

[1]	张翔, 王晓溪, 王海波, 张飞, 石凤健. ECAE法制备铜铝双金属复合棒材数值模拟与试验研究[J]. 金属热处理, 2023, 48(10): 291-296.
[2]	张锦刚, 晁利宁, 汪强, 杨晓龙, 周新义, 唐家睿. 消除大型结构件焊接畸变的焊后热处理工艺[J]. 金属热处理, 2022, 47(2): 236-242.
[3]	臧岩, 王建军. Cr-Ni-Mo系齿轮钢端淬过程模拟及淬透性预测[J]. 金属热处理, 2022, 47(2): 257-261.
[4]	贺瑞军, 冯润华, 韩啸, 孔令利. 基于Fluent的真空固溶热处理炉内温度场流体场分析[J]. 金属热处理, 2022, 47(12): 252-257.
[5]	于春鹏, 王立强, 汤贞涛, 陈丽丽. 铝合金大型锻件淬火过程的有限元模拟[J]. 金属热处理, 2021, 46(9): 279-283.
[6]	王晓林, 乔娟娟, 李强, 郭辉. 70Si2MnV钢球淬火过程的有限元模拟[J]. 金属热处理, 2021, 46(4): 100-104.
[7]	张家元, 李苹, 曾祺. 真气垫炉内漂浮换热过程数值模拟及结构优化[J]. 金属热处理, 2020, 45(9): 248-256.
[8]	刘华英, 彭新元, 唐龙书, 李超. 不同流速下AP1000主管道淬火过程温度场的有限元模拟[J]. 金属热处理, 2020, 45(8): 147-151.
[9]	李扬, 黄中华, 沈子豪. 不同降温速率下带焊缝304LN钢的热应力对比[J]. 金属热处理, 2020, 45(5): 97-102.
[10]	王章忠, 巴志新, 李琦, 刘永刚, 崔磊, 刘朗峰, 董继武. 热冲压工艺参数对22MnB5马氏体钢汽车B柱性能影响的有限元模拟[J]. 金属热处理, 2020, 45(5): 221-228.
[11]	胡春海1，王常建1，秦占领1，张黎旭1，张敏2，褚巧玲2，陈引妮2，刘娟娟2. 大型固体发动机壳体热处理工艺优化数值模拟[J]. 金属热处理, 2016, 41(5): 172-176.
[12]	李德英，赵龙志，张坚，姜羡. 超声振动对激光熔覆TiC/FeAl复合涂层温度场的影响[J]. 金属热处理, 2015, 40(3): 190-194.
[13]	李继红，陈引妮，褚巧玲，范文婧. 15MnNiCrMoV钢叶轮焊后热处理数值模拟[J]. 金属热处理, 2015, 40(2): 190-194.
[14]	张敏, 范文婧, 褚巧玲. 风机叶轮热处理工艺优化的数值模拟[J]. 金属热处理, 2014, 39(5): 132-137.

气垫炉中铜带材漂浮行为的数值模拟

Numerical simulation on floating behavior of copper strip in air cushion furnace

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 14

编辑推荐

Metrics

本文评价