| [1] |
Wang Yinghu, Zheng Huaibei, Liu Tingyao, Song Lingxi, Bai Qingqing.
Effect of solid solution treatment on microstructure and carbides of 53Cr21Mn9Ni4N heat-resistant steel
[J]. Heat Treatment of Metals, 2022, 47(4): 39-45.
|
| [2] |
Chen Sijun , Chen Songyi, Chen Geng, Yuan Dingling, Chen Kanghua.
Effect of Mg content on microstructure and mechanical properties of 2A14 aluminum alloy
[J]. Heat Treatment of Metals, 2022, 47(4): 86-92.
|
| [3] |
Bai Qingqing, Zhang Zhihong, Zheng Huaibei, Wang Yinghu.
Precipitation behavior of σ phase in 2507 super duplex stainless steel
[J]. Heat Treatment of Metals, 2022, 47(4): 108-115.
|
| [4] |
Chen Gang, Luo Xiaobing, Chai Feng, Yang Caifu, Zhang Zhengyan, Yang Li.
Influence of rolling heating temperature on microstructure and impact property of a high strength low alloy steel
[J]. Heat Treatment of Metals, 2022, 47(4): 116-121.
|
| [5] |
Li Li, Zeng Yan, Wu Xiaochun.
Heat treatment process optimization for 4Cr5Mo2VCo steel
[J]. Heat Treatment of Metals, 2022, 47(4): 133-140.
|
| [6] |
Zhao Xin, Chen Zhengzong, Zhao Haiping.
Simulation of heating process for martensitic heat resistant steel G115 heavy pipe blanks
[J]. Heat Treatment of Metals, 2022, 47(4): 208-212.
|
| [7] |
Luo Diqiang, Yu Yinhong, Zhang Zhenming, Feng Xiaoming, Liu Min, Lai Chaobin.
Effect of yttrium-based rare earth on inclusions and cryogenic temperature impact property of high strength shipbuilding steel
[J]. Heat Treatment of Metals, 2022, 47(3): 142-146.
|
| [8] |
Wu Yingfei, Sun Zhonghua, Wang Yufei, Wang Chengming, Zhang Yunfei, Peng Huifen.
Effect of homogenizing on microstructure and properties of Invar alloy ingot
[J]. Heat Treatment of Metals, 2022, 47(2): 130-136.
|
| [9] |
Zhao Xin, Chen Zhengzong, Zhao Haiping.
Finite element analysis of novel martensitic heat-resistant steel G115 heavy castings
[J]. Heat Treatment of Metals, 2022, 47(2): 229-235.
|
| [10] |
Yu Hongjun, Song Chuansongxin, Cheng Fuchao, Gao Zhizhe, Chen Xiaoyan, Wang Yongjin, Zhang Yingchao.
Microstructure and properties of a hypoeutectic high-Cr cast iron under different heat treatment conditions
[J]. Heat Treatment of Metals, 2021, 46(8): 56-60.
|
| [11] |
Zhao Peilin, Liu Chao, Wu Huiliang, Zheng Li.
Effect of normalizing temperature on microstructure and low temperature toughness of 355 MPa heavy section steel for marine engineering
[J]. Heat Treatment of Metals, 2021, 46(6): 102-106.
|
| [12] |
Yang Hao, Si Yu, Cao Pengjun, Li Kejian.
Research status of failure mechanisms of heat-resistant steel in thermal power units
[J]. Heat Treatment of Metals, 2021, 46(5): 14-24.
|
| [13] |
Shen Kang, Cai Wenhe, Du Shuangming, Dong Shuqing, Gao Dawei, Bai Yin.
Effect of shot peening on high-temperature steam oxidation behavior of martensitic heat-resistant steel
[J]. Heat Treatment of Metals, 2021, 46(2): 66-73.
|
| [14] |
Sun Liguo, Zhou Jian, Ma Dangshen, Chi Hongxiao.
Effect of solution pretreatment after forging on annealed microstructure and impact property of H13 steel
[J]. Heat Treatment of Metals, 2021, 46(2): 130-135.
|
| [15] |
Peng Siyuan, Deng Xiangtao, Liang Liang, Fu Tianliang, Liu Ning, Wang Zhaodong.
Effect of quenching temperature on microstructure and properties of novel NM450 corrosion-wear resistant steel
[J]. Heat Treatment of Metals, 2021, 46(12): 223-228.
|
